REVO S 1PH Thyristor Power Controller
REVO S 1PH Thyristor Power Controller
- REVO S 1PH Thyristor Power Controller is suitable for resistive and medium or long wave infrared loads
- Current range – 30A, 35A, 40A, 60A, 90A, 120A, 150A, 180A, 210A, 280A, 400A, 500A, 600A, 700A
- Supply voltage up to 480V or 600V AC as option
- Fully isolated from the power
- Zero crossing firing mode (ZC) or Burst Firing (4, 8 or 16 cycles selectable)
- Logic input signal 4 to 30V DC typical (SSR) plus 4-20mA or 0-10V DC Linear input as an option
- Constant current drain, independent of supply voltage with SSR input
- Heater Break (HB) alarm to diagnose partial or total load failure with automatic setting, relay alarm output and front LED indication. Available as an option
- Side by side mounting
- Special design Heatsink with high dissipation value
- IP20 protection
- Complies with CE and cUL (pending)
- Can be used in conjunction with REVO-PC to provide multi-zone control
Related Products
REVO PC Reduce Power Peaks and Maximise your Savings
- Suitable for Normal Resistance and IR Lamp
- To be used with REVO S and REVO Sx
- Firing Mode: SC, HC and Dynamic Burst Firing
- Reduce Peak of Power and let you save Energy
- Modbus RTU, Profibus, Profinet, Modbus TCP, Ethernet IP and other fieldbus
- Heather Break Alarm
REVO TU Flat Cable Wiring System
- Terminal Unit for Simplificated wiring of Heater Break Option
- Available for REVO SSR up to 40A and Revo SSR
- Push Button and DI for HB tuning