REVO E 3PH Thyristor Power Controller

REVO E 3PH Thyristor Power Controller (CD3000E 3PH) is a Universal and Digital Unit based on configurable powerfull microprocessor. It is possible to configure all inputs, the firing mode and control mode for all load type.

  • Thyristors suitable for most applications including Short Wave Infrared (SWIR) & Inductive load types
  • Current range – 35A, 45A, 75A, 100A, 125A, 150A, 225, 300A, 350A, 400A, 450A, 500A
  • Three leg switching of 3/4 wire star or 3/6 wire delta loads
  • Fully digital and user configurable for all inputs, firing modes, feedback modes and load types
  • Firing modes include zero crossing (ZC), burst firing (BF), single cycle (SC), soft start + burst firing (S+BF) and phase angle + soft start (S+PA)
  • Microprocessor based electronic circuit fully isolated from power
  • Universal input signal with automatic zero/span calibration
  • Power feedback or voltage compensation
  • RS485 Comms MODBUS protocol as standardUnbalanced loadHeater break alarm to diagnose partial or total load failure and short circuit
  • Control & monitor power, current & voltage via external keypad (CD-KP)
  • IP20 Protection
Thyristor Configurator V5.3.0.7- CD3000 series - MULTUDRIVE (17,1 MB, 298 downloads)

Related Products

CD-RS RS232 to RS485 RS422 Signal Converter 2500V Insulation
CD-RS RS232 to RS485 RS422 Signal Converter 2500V Insulation
  • Configurable communication 
  • RS485 or RS232RS232 front panel connector
  • 2500V insulation between input and output
  • Side by side mounting
  • DIN rail mount or bulk head mounting
  • Input and output data transfer LED indication
TU-RS485-ETH-DL-IO Ethernet to Modbus Converter
TU-RS485-ETH-DL-IO Ethernet to Modbus Converter
  • N.1 serial interface RS-485 Modbus RTU Master
  • N.1 serial interface RS-485/232 Modbus RTU Slave
  • USB Port with USB 8GB Memory Key for Data Logging
  • Interface Ethernet 10Base-T, Modbus TCP
  • N.4 Digital Inputs + N.2 SPDT Relays
  • Functional Block programming software
TU-RS485-PB Profibus DP to Modbus RTU Converter
TU-RS485-PB Profibus DP to Modbus RTU Converter
  • Protocol Converter / Gateway from serial interface to PROFIBUS DP
  • The PROTOCOL CONVERTER TU-RS485-PB connects devices such as thyristor units, controller and soft starter via their serial interfaces to Profibus DP. RS232, RS485 und RS422 interfaces are on Board as a standard feature.
REVO KP2
REVO KP2
  • Up to 6 zone can be managed
  • 4.3, 7.0, 10” Colour Display
  • Trend display
  • Thyristor Configuration Recipy Management
  • Multi Language Interface
  • For REVO M, REVO CL, CD3000E and MULTIDRIVE.
CD KP Operating terminals for Thyristor Units
CD KP Operating terminals for Thyristor Units
  • Operating terminals for Thyristor Units
  • N°2 Display
  • 48x96 Front Panel
  • Re-Transmission
  • Thyristor Configuration Port
  • Multi Language Interface
  • For CD3000M, CD3200, CD3000E and MULTIDRIVE.